Laundry front loading washer displaying Error Code HO SE reversed hose detection.

Issue

  • Laundry washer displays Error Code HO SE.
  • Problem with hot and cold water switch.

Applies to

  • Front loading laundry washers.

Solution

Error Code HO SE means condition is detected where the inlet hoses have been installed incorrectly (hot supply to cold inlet and cold supply to hot inlet), the washer will alert you.

Troubleshooting

  • Note: Make sure you turn off the water first.
  • LED will display “HO” followed by “SE” and then the remaining cycle time (0 min) for 60 seconds and then repeat.
  • Press the cancel button.
  • Shut off each water supply valve and attach each supply hose to the correct inlet connection on the washer.

IF YOU WERE UNABLE TO RESOLVE YOUR ISSUE

  • For units installed within the past 30 days, please refer back to your installer to resolve this issue.
  • For units installed after 30 days please contact us to schedule service.

Was this article helpful?

Register Your Appliance

Let's make it official! Take the first step to becominga part of the Frigidiare Familty

Register now

Warranty & Service Support

Locate and expert in your area who can help diagnose and resolve an issue with your appliance.

To service support